![]() |
Eden board - Printable Version +- Forums (http://www.taban-miniatures.com/forum) +-- Forum: Eden (/forumdisplay.php?fid=1) +--- Forum: Hobby and creations (/forumdisplay.php?fid=12) +---- Forum: Modelling and sceneries (/forumdisplay.php?fid=14) +---- Thread: Eden board (/showthread.php?tid=1607) Pages: 1 2 |
Eden board - Corpuscle - 11-14-2013 12:38 AM Over the last few weekends I've been working on an Eden board, and finally all the painting is done. All I need to do now is add dullcoat, pigments and grass tufts and it's done! [img] ![]() Now I need to get started on the scatter terrain. RE: Eden board - Lemminkäinen - 11-14-2013 01:09 AM That is looking ridiculously sweet. The level of painting on that board is crazy! Individually highlighted cracks - sheesh. Amazing! RE: Eden board - Addam - 11-14-2013 11:13 PM Great looking table. Would love to see it all in one shot. RE: Eden board - Kamaro - 11-15-2013 06:11 AM Nice board, now take a picture from the whole deal! ![]() RE: Eden board - Corpuscle - 11-19-2013 09:01 AM (11-15-2013 06:11 AM)Kamaro Wrote: Nice board, now take a picture from the whole deal!I'll do that this weekend once I've got hold of what I need to finish off the edges ![]() WIP work on the scenery is below using the rulebook as a guide for basing sizes. Small low ruined wall... ![]() Small chain-link fence... ![]() Medium sized ruined wall section... ![]() ![]() and large acid pool/silo... ![]() Currently working on a medium radioactive waste cylinder and large ruined wall section, but this might change depending on what I get my hands on at the hardware store. RE: Eden board - Addam - 11-19-2013 11:07 PM Wow, those are some great pieces of scenery. What did you use for the chain linking? RE: Eden board - Kamaro - 11-21-2013 08:51 AM Wow nice pieces, they perfectly match into the Eden universe! @Addam if you are talking about the fencing, those are sold in every hardware store in nets. But I have no idea where the razorwire comes from ^^ looks like etched brass RE: Eden board - Corpuscle - 11-22-2013 08:40 AM What Kamaro said, brass-etch razor wire (I can't remember where from), plastruct tubing and mesh from Antenocitis Workshop http://www.antenocitisworkshop.com/ I really can't recommend them enough for scratch-building stuff. RE: Eden board - Mordread - 11-23-2013 04:01 PM Very impressive work. Carry on RE: Eden board - Corpuscle - 01-12-2014 07:42 AM Here's the finished article! ![]() ![]() |